modif-motor-race

Consider the following tips:
1. Piston. To modify your bike in order to be faster the speed, you have to reduce the weight of the piston so that the motor power increases because of energy lost to counter heavy piston. To reduce the weight of the piston, you can cut off the bottom of the piston, the magnitude of the cut section is already certain (sure) and each bike is not the same.
2. Cylinder head. In the process of modifying your motor, fuel compression chamber will determine the power generated. In principle, the higher the compression the more fuel-generated power. To enhance the combustion chamber compression can be done by reducing the volume of the combustion chamber. In general, a motorcycle, this is done by grinding the cylinder head so that the engine is reduced and the compression increases.
3. Rinse hole. The number of new gas mixture of gasoline and air is put into the combustion chamber is crucial ternaga motors produced. The more condensed gas means that the higher the density of the gas compression pressure rises and better combustion. To achieve this, flushing holes (intake) expanded to the number of new gas in more. Expansion bilans hole must remain at a certain boundary and accompanied bataa modifications in other parts. If this is not done then the motor instead of increasing strength, but it becomes damaged.
4. Electrical System. Electric power to the motor kebyakan 6 volts. Tagangan can be converted to 12-volt electrical system to change. With a voltage of 12 volts, the lights became brighter, horn becomes harder and spark plugs become larger.
5. Rocker Arm. Rocker arm or sleeve valve pounder also serves to continue the movement of the rod pressure (push rod) or from pam shaft so that the valve can be opened and closed. Good rocker arm is a lightweight but strong. If the cuts will lead to excessive rocker arm rocker arm to be easily broken.
6. Gears. Modif bike was done so that the speed of the motorcycle increases the power of the same engine, rear gears should be replaced with a smaller diameter, if the gear is replaced with a smaller wheel ranta course length must be reduced and adjusted.